Industrial Cameras FAQ/Application fails to open a ca...

Application fails to open a camera, when the application is started again after it terminates abnormally.　By inserting the camera cable after removing it, the application will operate normally.（No.252）

TeliCamSDK PkgVer 1.0.7.1 or earlier contains an issue that application may fail to open a camera if restarting the application without disconnecting the camera cable once after the application terminated abnormally.

This issue has been fixed in PkgVer 2.0.0.1. In each version up, we make bug fixes, correspond to new camera models, improve functions etc. We recommend you to use the latest version of TeliCamSDK.

back

Was this FAQ helpful?

Please let us know your opinion about the FAQ so that we will be able to improve our FAQ. (Within 800 characters)
Note: If you need a reply to your inquiry (e.g. inquiry about products), please use the inquiries form provided on Contact Us page. Please note that we cannot answer to your questions filled in below.

Please click below to change the cookie settings used on our website.

Copyright © 2024 Toshiba Teli Corporation, All Rights Reserved.