Industrial Cameras FAQ/When acquiring images in softw...
When acquiring images in software trigger mode, is it necessary to start and stop the stream each time acquiring a single image?(No.295)
After opening and starting stream, you can issue the software trigger command any number of times, one image is taken each time a software trigger command is issued.
The camera does not accept the next software trigger command while the camera is performing the imaging acquisition receiving a software trigger command.
Issue software trigger command after receiving the image being acquiring, or issue software trigger command after the FrameTriggerWait event became active.
The camera does not accept the next software trigger command while the camera is performing the imaging acquisition receiving a software trigger command.
Issue software trigger command after receiving the image being acquiring, or issue software trigger command after the FrameTriggerWait event became active.